Now go to Exit, select Exit Saving Changes and press return. Important: If Supervisor password is does not read Clear, repeat the last step to ensure there is no supervisor password set. This means that we un-set our supervisor password. In the Enter new password and Confirm New Password fields, DO NOT ENTER ANY PASSWORD! Just press return two times.ĭouble-check that Supervisor password is now read Clear.
#Insydeh20 setup utility hp legacy bios boot mode driver
Go to the Security tab again, go to Set Supervisor Password and press return.Įnter the password you used before (e.g. Download and run the file linked above H2OEZEx86 100 BIOS is also used to identify and configure the hardware in a computer such as the hard drive, floppy drive, optical drive, CPU, memory, etc There is no risk of installing the wrong driver When you unzip it, then it contains a When you unzip it, then it contains a. Now we will unset the supervisor password. Now go to the Boot tab where you can now disable Secure Boot. On the top of the page, Supervisor password is should now read Set. If you forget your supervisor password you WILL BRICK YOUR MACHINE! This password will only be used temporarily so you DO NOT want to use a secure password!Įnter the password, press return, enter the password again and press return again. Important: DO NOT use a hard-to-remember password here! I recommend using abc123 as a password and writing it down just in case. This will show a prompt to set a supervisor password. Go to the Security page and navigate to Set Supervisor Password. In order to change it you need to temporarily set a supervisor password in the BIOS. When accessing the BIOS/UEFI by pressing the F2 key during boot, the Secure Boot option is and greyed out so I couldn’t change it. On my Acer Aspire A515-52-51EL Secure Boot is enabled by default.